Evaporating liquid with a heat source causes additional damage and is not recommended. Dry out your iPhone by laying it in a safe, dry place. Allow at least 48 hours for the liquid to evaporate before reinserting the SIM components or turning on the iPhone.
According to Apple, it might take up to 24 hours for your iPhone to fully dry. You should wait at least 30 minutes before charging your iPhone 11 with a lightning cable, otherwise, you can permanently damage it.
Setting Up a Water Ejection Shortcut on iPhone
Eject Water From Your iPhone Speaker With Silica Gel or Rice You can also try to get the water out of your iPhone speaker by putting it in a blow full of unboiled dry rice or a few silica gel packets. The difference between rice and silica is that with rice, it will take much longer than with silica beads.
2:083:23Open that app and place your iphone on a flat surface. Now make sure your iphone volume is full andMoreOpen that app and place your iphone on a flat surface. Now make sure your iphone volume is full and set to the maximum tap and hold down to the water drop icon.
Use boiling water It can also be used to potentially remove unwanted depressions in your vehicle, that is, as long as you have a plastic bumper and are successfully able to access the dent from the backside.
Spilled water on macbook - drain water away from the macbook Any water that has already got into the logic board will also be pulled into a less vulnerable section. With the bottom cover removed, the water damage MacBook should be dried after 24 hours.
Unlike Apple Watch, there is no official way to eject water from the speaker grills, even though the modern iPhones are water-resistant. It not only muffles audio but also causes severe damage if the water is not ejected.
To dry your iPhone, tap it gently against your hand with the Lightning connector facing down to remove excess liquid. Leave your iPhone in a dry area with some airflow. Placing your iPhone in front of a fan blowing cool air directly into the Lightning connector might help the drying process.
Use a dry towel or cloth to wipe any moisture away from its exterior. If water has gotten inside the device, place it in a dry environment, and give it time to evaporate. The rice trick mentioned before is because rice grains can help absorb moisture, but a dry room will work just as well.
You can run Water Eject for 15 minutes or indefinitely. If water remains lodged in your iPhone, Apple recommends that you wipe your device with a soft, lint-free cloth, like a lens cloth. You should then place the charging port against your palm and gently tap it down a few times to remove any trapped water.
To dry your iPhone: Tap your iPhone gently against your hand with the Lightning connector facing down to remove excess liquid. Leave your iPhone in a dry area with some airflow. After at least 30 minutes, try charging with a Lightning cable or connecting a Lightning accessory.
Wipe your iPhone with a lens cloth. Gently tap your iPhone against your hand, Lightning connector facing down, to encourage water to drain out. Leave your iPhone speakers facing down in a dry area with good airflow. You can position a fan to blow cool air into the speakers.
Open Shortcuts and go to the My Shortcuts screen. Tap the Water Eject shortcut to run it. Press Start.
If your iPhone XR gets wet, wipe it down, turn it off, and disconnect any cables. Then gently tap it against your hand with the Lighting port facing down to remove any excess water. You can also put your iPhone in front of a fan blowing cool air into the Lightning port to dry it off.